Join Kontakan

Join Kontakan to add friends, message members, view photos, post comments and receive exclusive access.

Click here to register

Kontakan Suggestions

Tip #10: Share an embarassing story and laugh about it

Hydraulic ball valves have been developed specifically for hydraulic and heating systems | Forum

Topic location: Forum home » General » General Chat
Nichole Logan
Nichole Logan Jun 17
Ball valves are intended with a ball inside valve. The ball carries a hole over the middle to ensure when the hole was in line with each side of the valve, flow will occur. When the valve is closed by turning the ball 90 degrees, the opening is perpendicular on the ends from the valve, and so flow is blocked check this link . Ball valves are incredibly durable and in most cases have excellent shutoff even though years of use. They usually are preferred over globe valves in shutoff applications. The main limitation for ball valves is proportional control because in the large amount of flow the ball allows.

Ball valves in sizes approximately 2 inch generally are available in single piece, a couple of piece designs. One piece ball valves have been reduced bore, are pretty cheap and generally are throw-away. Two piece ball valves are usually slightly reduced (or standard) bore, they are often either throw-away or repairable. The 3 piece design provides for the center part on the valve containing the ball, stem & seats for being easily taken out of the pipeline view more . This facilitates efficient cleaning of deposited sediments, replacing of seats and gland packings, polishing away from small scratches on your ball, this without taking off the pipes in the valve body. The design reasoning behind a three piece valve is perfect for it to get repairable.

Hydraulic ball valves have been developed specifically for hydraulic and heating systems this can high operating pressure rating and hydraulic and heating oil resistance. These valves are constructed with either steel or metal. Besides these materials, the seats also make hydraulic valves appropriate for high operating pressure. The seats of such valves are created from polyoxymethylene (POM), which is well suited for high pressure and low temperature applications. The maximum operating pressure of hydraulic ball valves goes above 500 bar as the maximum temperature goes nearly 80°C.

Flanged ball valves are seen as a their connection type. The ports are attached to a piping system via flanges which are usually developed in accordance which has a certain standard. These valves offer a high flow rate given that they typically have a full-bore design. When choosing a flanged ball valve, aside from the pressure rating, you might also need to check the flange compression class which indicates the very best pressure this connection type can withstand. These ball valves are created with two, 3 or 4 ports, they may be approved for specific media, produce an ISO-top and everything a standard ball valve may have.